D200175 PMM 多形式光纤收发器

D200175 PMM多形式光纤收发器

D200175 PMM 是一款多形式光纤收发器，支撑多种不同的光纤传输形式。该产品具有以下标准和技能阐明

传输速率:最高可达 10 Gbps

传输距离:取决于所运用的光纤类型和传输速率

接口类型:LC 接口

波长:850 nm/1310nm/1550 nm

工作温度:0°℃ 至 70°C

供电电压:3.3VDC

2、显现VTYP承认阀门类型:ROE代表角行程、LIN代表直行程

(“+”"-”键挑选，ENTER键承认进入下一步参数设置，C键取消返回上级菜单)

3、显现ATYP承认执行器类型:1-A代表单效果、2-A代表双效果

4、显现PFA承认阀门毛病方位:CLO代表毛病关、OPE代表毛病开

5、显现ROT承认阀门旋转方向(顺时针、逆时针):CC代表顺关阀、CCC代表逆关阀

6、显现AO(死区):承认阀门的死角:默认为0，一般不需要更改、如需更改的话改到0.6

7、设定完屏墓显现“AUTO CAL”闪耀时按ENTER键承认，定位器主动调试。调试过程中显现"CALRUN”，调试完毕显现"CALBRAIIONSUCCESSFUL”，调试过程中按C取消操作，中止校验，调试完毕后，按C两次退出

D200175 PMM multi-form fiber transceiver

The D200175 PMM is a multiform fiber transceiver that supports a variety of different fiber transmission forms. The product has the following criteria and skills stated

Transmission rate: up to 10 Gbps

Transmission distance: depends on the type of fiber used and transmission rate

Interface type :LC interface

Wavelength :850 nm/1310nm/1550 nm

Operating temperature :0° C to 70°C

Supply voltage :3.3VDC

2, the VTYP recognizes the valve type :ROE represents angular stroke, LIN represents straight stroke

(" + ""-" key selection, ENTER to admit to enter the next parameter setting, C key cancel to return to the upper menu)

3, show ATYP recognizes the actuator type :1-A represents single effect, 2-A represents double effect

4, show PFA to recognize the fault location of the valve :CLO represents the fault close, OPE represents the fault open

5, show ROT to recognize the valve rotation direction (clockwise, counterclockwise):CC represents the turn-off valve, CCC represents the reverse turn-off valve

6, show AO(dead zone): recognize the dead Angle of the valve: the default is 0, generally do not need to change, if need to change to 0.6

7, after setting the screen tomb appears "AUTO CAL" shine, press the ENTER key to acknowledge, the locator actively debugging. During debugging, "CALRUN "will be displayed, and after debugging," Calbraiion successful "will be displayed. During debugging, press C to cancel the operation and stop the verification. After debugging, press C twice to exit